- Folding Phone Holder
- $2.96
Welcome to my store.
Each week during Development I go through some steps of drawing out the project.
I do some tests with ideas and at times cardboard or paper model testing.
During this time I also do a evaluation of problem solving.
During the Modeling stage a 3D software is used to create the project from the Development
stage. During this time of 3D Modeling a few checks and evaluations are done.
The next part is testing that is being done through out the developming and modeling stages.
Once the test stage is gone through the next step is to 3D print the model.
During the 3D print each model is reviewed for any problems furing testing to solve before a full
print is lost. This is why I don't add lost of product cost to my prints. Each test of 3D printing is
done with a good quality print to happen from that point on.
Teach test print is then tested for there function.To watch the projects visit the stream.
https://www.twitch.tv/primemac_studio